ASTM D 5840-1995 用于铺路建筑的沥青水泥的2型聚合体改型的标准规格

上一篇: ASTM C 308-1995 耐化学腐蚀树脂灰浆施工时间,凝固时间及维护凝固强度时间的试验方法
下一篇: ASTM D 5788-1995 有机物在水中样本的峰值标准导则

Product Code:SAE AMS4067
Title:Aluminum Alloy, Drawn Round Seamless Tubing, 1.25Mn - 0.12Cu (3003-H14), Strain Hardened (Cancelled Jul 2007, Superseded by ASTM B 210, Alloy 3003, Temper H14)
Issuing Committee:Ams D Nonferrous Alloys Committee
Scope:This specification covers an aluminum alloy in the form of seamless drawn tubing.Product Code:SAE J1742
Title:Connections for High Voltage On-Board Road Vehicle Electrical Wiring Harnesses - Test Methods and General Performance Requirements
Issuing Committee:Connector Systems Standards Committee
Scope:SCOPEProcedures included within this specification are intended to cover performance testing at all phases of development,production, and field analysis of electrical terminals, connectors, and components that constitute the electrical connectionsystems in high power (20 V to 600 V and/or >80 A) road vehicle applications. These procedures are applicable only toterminals used for In-Line, Header, and Device Connectors and for cable sizes up to 120 mm2 (4/0).In cases where power levels are mixed in the same connector, (i.e. sensing or normal 14.5 V system circuits with HighPower Contacts) the High Power Contacts must pass SAE J1742 requirements, and all other contacts must pass SAEJ2223-2 requirements. The connection system (housing and high power contacts) shall meet SAE J1742 requirements.The requirements and procedures in this document are not intended for connections internal to electrical/electronicmodules or complete subassemblies.This document does not contain a test for EMI/EMC since these parameters must be tested as a combination of cableand connector. These are considered system level requirements. Determination of the need and type of test must beconsidered at that level.See Appendix C, Design Notes for further information.